![]() The mask's cheekbones were generally angular, curving slightly to join the nose at its base. The ridged bridge of the nose seemed lost in the largeness of the eyes, but jutted out in a manner similar to a bare Human skull. This front part of the mask was of a more highly polished black material than that of the back, being the more flexible of the two. The face of the mask was somewhat exaggerated and angular, with two ridges above his eyes that fit in with those of his helmet. Also hidden beneath his mask were four red heat dispersion vents, accented by yellow wire. Around the part of the mask covered by the helmet was the external neural sensor array. An implanted enunciator linked to an electronic voice processor enabled Vader's scorched vocal cords to produce speech. The air pump itself was located inside the top of the mask, which, via a ventilator, supplies a distinctive rasp. Made of black durasteel, these components were hermetically sealed and connected with a flat backpack that cycled air to Vader's lungs. This disc served as an interface between the mask and the helmet. ![]() The top of this mask was crowned with a circular interface dotted with an array of square slots around a disc of silver. The mask's appearance was given a similar appearance to a skull in order to enhance the fear factor of the Dark Lord of the Sith. The mask itself went halfway around Vader's head. ĭarth Vader's helmet/breath mask blueprints Besides protection, it also stuck needles into Vader's skin when fixed in place, which feed neurological data on brainwave activity to the central chest computer, and possessed radiator conduction pads that were installed into the helmet as a means to allow excess heat to bleed through the metal surface. This helmet locked into the mask, via a pressurized seal comparable in integrity to a Class C spacesuit. The jagged edges also acted as a means to deflect potential energy blows onto the thick shoulder armor. ![]() Two less jagged ridges swept over the eyes of Vader's mask proper and served to accent them. In addition, it was also rumored that the helmet's already strong metallic hull had also been further strengthened via dark side alchemy, with the specific technique not being found in the database of the Rhinnal Medical Academy. The front was carved out to fit around his head and show his "face." This helmet had a raised ridge that ran from between his eyes to the back of his head, where it merged into the durasteel, obsidian, and plasteel of the helmet itself. Like traditional Sith armor and patterned after that of ancient Sith droids, Darth Vader's suit was made to be both intimidating and fearsome.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |